2.1 RECUMBENT SEAT HEIGHT
To adjust the seat height on the Recumbent Cycle, locate the yellow lever
under the right side of the seat before you mount the Cycle. Place your right
hand on the yellow adjustment handle under the right side of the seat. Place
feet on the ground while seated and slide forward if needed. Place feet on
pedals, gently lift lever under the right side of the seat. Using legs, slowly
push and slide the seat up or down to desired position. Release lever and
allow to lock into place.
2.2 UPRIGHT SEAT HEIGHT
To adjust the seat height on the Upright Cycle, locate the yellow pull pin
before you mount the Cycle. To raise or lower the seat, pull the yellow knob
while holding the seat with the other hand and slide up or down accordingly.
Make sure you are not seated when you pull the knob or pull the seat up.
2.3 HYBRID SEAT HEIGHT
To adjust the seat height on the Hybrid Cycle, pull the yellow lever under the
seat and lower the seat to the lowest position, stand over the seat and grab
the yellow lever. Pull the lever and lift until the seat base makes contact with
your pelvic bone.
Cycles_OM_090430.indd 2 4/30/09 10:40 AM
To Next Page
Loading...
