26
Never operate product if it has a damaged cord or plug, if it is not working properly, if it has been damaged, or
immersed in water. Contact Customer Tech Support for examination and repair.
POWER
If your unit is powered by a power supply, the power must be plugged into the power jack, which is located in the front
of the machine near the stabilizer tube. Some units have a power switch, located next to the power jack. Make sure it
is in the ON position. Unplug cord when not in use.
WARNING
MOUNTING THE STEPPER
1) Stand behind the unit.
2) While holding both of the rear arm handles, place one foot on the corresponding footpad. Wait until the footpad
comes to a stop at the bottom of the stroke.
3) Then place your other foot on the opposite pedal.
To Next Page
Loading...
