With Demo Mode enabled, the console emulates any signals to or from the MCB/LCB and ignores any
errors. Response to speed, resistance, and incline commands within the console will register as
expected but will not be acted on by the frame in Demo Mode.
Run Machine Mode
Run Machine mode allows the frame, the console will start the frame as though it was in a manual
workout with minimum settings and no time limit. Speed, incline, resistance, HR response, frame
hardware button response, and other settings can be controlled directly: TreadSense, user detection,
and minimum RPM requirements are disabled to allow hardware testing and adjustment.
To enable Run Machine Mode:
1. Access the Product Dashboard by touching and holding on the Matrix logo, top center of display.
2. Press the “Machine Settings” button.
3. Type “3 0 0 1 enter” on the keypad that appears to access Machine Settings menu.
4. Touch on the “Calibration” tab.
5. Touch on the “Run Machine” tab that appears.
6. Adjust available parameters as needed and press the “Run Machine” button.
Time Zone Reference
The console Time Zone selection is simply a number – use this table to determine the correct selection
for the location.
Time Zone Table
Used for Wi-Fi Configuration files
To Next Page
Loading...
