Matrox Millennium G400 - Page 14

14 Matrox Graphics Card – User Guide
b
Before Windows starts, press [F8] for the Windows startup menu to appear. (With
Windows 98, if [F8] doesn’t work, instead try pressing and holding [Ctrl] before
Windows starts.)
c
Select “safe mode”, then press [Enter].
2
Right-click the Windows desktop background, then click Properties Æ Settings .
3
Move the Desktop area (Windows 95) or Screen area (Windows 98/2000) slider down
to its lowest setting, then click
OK .
4
Restart your computer normally.
5
Make sure the correct monitor is selected in Windows (see “Monitor setup”, page 6).
6
Windows 95/98 – Make sure you’re not using inappropriate monitor setting
customizations: Access the PowerDesk
Monitor Settings property sheet (see “Accessing
PowerDesk property sheets”, page 6), then click
Delete all customizations .
7
Restore your original display settings (see steps 2 and 3).
Windows NT 4.0 –
1
If your primary display is unusable:
a
Press [Ctrl]+[Alt]+[Del] Æ [Tab] Æ [Tab] Æ [Enter] Æ [ È ] (down arrow) Æ [Enter]
to restart your computer.
b
From the startup menu, choose “ VGA mode ”.
2
Right-click the Windows desktop background, then click Properties Æ Settings .
Windows may prompt you that the display settings are incorrect for the current mode;
click OK to continue.
3
Move the Desktop area slider down to its lowest setting, then click OK .
4
Restart your computer normally.
5
Select a monitor with the Matrox PowerDesk Monitor property sheet, then adjust your
display settings. For more information, see the Matrox PowerDesk online
documentation.
Note: In multi-display mode (see “DualHead Multi-Display setup”), each monitor has its
own monitor settings (refresh rates).
NTNT