Matrox Millennium G400 - DualHead Multi-Display Setup; Windows 98

8 Matrox Graphics Card – User Guide
DualHead Multi-Display setup
If your Matrox graphics card has a second monitor connector (see page 4), you can enable a second
display (for example, a computer monitor or a TV) as part of your Windows desktop. This is the
Matrox
DualHead Multi-Display feature. To use this feature:
Windows 98 –
1
Access the PowerDesk DualHead property sheet (see “Accessing PowerDesk property
sheets”, page 6).
2
Select the DualHead Multi-Display option button.
3
Click OK Æ Yes to restart your computer and for changes to take effect.
4
If multi-display mode isn’t automatically enabled when you restart Windows:
a
Right-click your Windows desktop background, then click Properties Æ Settings .
b
Select the disabled display, enable the Extend my Windows desktop onto this
monitor
check box, then click OK .
Windows 2000 –
1
Access the PowerDesk DualHead property sheet (see “Accessing PowerDesk property
sheets”, page 6).
2
Select the DualHead Multi-Display option button.
3
Click Multi-Display Settings to adjust your DualHead Multi-Display settings. Click OK
when you’re done.
4
Click OK Æ OK for changes to take effect.
5
Move the Screen area slider to adjust your display resolution and to select single-display
or DualHead Multi-Display mode. A DualHead Multi-Display resolution is twice as
wide or tall as its corresponding single-display resolution. For example, 640 × 480 is a
single-display resolution and 1280 × 480 is a DualHead Multi-Display resolution.
6
Click OK to accept your changes.
Note: In DualHead Multi-Display mode under Windows 2000, Windows treats the main
and secondary displays as a single display (which the Matrox display driver divides between
two monitors). As a result, these displays always use the same resolution and color palette
settings. The resolution of both displays is limited by the display with the lower maximum
resolution.
9898
2k2k