35
PNP OS Installed Default: No
If you have installed a Plug and Play operating system such as Windows 95 or
98, you can change this item to Yes. When the item is set to Yes you can use
the Device Manager utility in the operating system to make changes to the
configuration of expansion cards.
Resources Controlled By Default: Manual
You should leave this item at the default Manual. If you find that you cannot get a
particular expansion card to work properly, you might be able to solve the
problem by changing this item to Manual, and defining the characteristics of the
card in the new items which appear.
In the default Manual, the display will list a series of items that allow you to
define the assignments of the system interrupt lines (IRQs) and Direct Memory
Access (DMA) channels. As a default, these items are set to PCI/ISA PnP. If you
install an ISA-bus card that does not support PNP, and it requires a special IRQ
and DMA, you can modify the list of assignments. Change the values of the IRQ
and DMA that are required to Legacy ISA.
Reset Configuration Data Default: Disabled
If you enable this item and restart the system, any PNP configuration data stored
in the BIOS setup will be cleared from memory. New updated configuration data
will be created.
Assign IRQ for USB Default: Enabled
When this item is enabled, the system will assign an IRQ to the USB ports.
To Next Page
Loading...
