Using your evaporative cooler
Do not use your cooler in hazardous areas.
Before you do anything make
sure that the rubber plug is firmly in
place.
Freeze your ice blocks until they
are solid if you intend to use them
in your evaporative cooler.
If you wish to use the ice blocks,
put them into the water inlet and
top up with water ensuring it does
not exceed the red arrow indicator.
DO NOT OVERFILL THE
WATER INLET.
Close the water inlet lid, connect
the power cord to a wall socket and
switch on. Press the on/off button
on the control panel to turn the unit
on.
Information
If you overfill the water
tank, place in an empty
bath and remove the
rubber stopper to
discharge excess
water.
i
To Next Page
Loading...
