4
Leveling the appliance
Once the appliance is positioned, adjust the feet(screw them in o rout) to adjust
the height of the dishwasher, making it level to ensure the proper performance.
Charging hose connection
1.Connect the charging hose to a water faucet(with a unicouple).See
figure 4.
2.If the water pipe is new or has not been used for an extended period
of time, let the water run to make sure that the water is clear and free of
impurities, then connect it with the charging hose of the dishwasher.
3.The water pressure is 0.04-1.00Mpa.
Drain hose connection
Insert the drain hose into a drain pipe, or let it run into a sink, but the
free end of the hose must be at a height of less than or equal to 80cm
and must not be immersed in water.
Electrical connection
1. After making sure that the voltage and the frequency values for the
current in the home correspond to those on the rating plate, insert the
plug into an electrical socket which is earthed properly. See figure 6.
2. If the electrical socket to which the appliance must be connected is
not appropriate for the plug, replace the socket rather than using a
adaptor or the like as they could cause overheating and burns.
1.3 Trial Running
After installation, choose any one of the programs to run to check the dishwasher functions
well.
MAX 100cm
MIN 40cm
To Next Page
Loading...
