Mattel Tyco R/C Stunt Psycho - User Manual

I.CONTENTS/FEATURES
• Vehicle
• Transmitter
Vehicle
q ON/OFF switch
w Battery door
e Battery door latch
Keep these instructions for future reference: they
contain important information. IMPORTANT: Please read
all “Consumer Information” before operating your vehicle.
CAUTION: Surfaces may become hot and cause burns
if electronics get wet. Do not operate vehicle through water
or snow.
Asst.M9639
N1929/N1930-XXXX
Transmitter
q Antenna
w Battery door
e Driving controls
6+
I
O
a
b
II.BATTERY INSTALLATION
Requires 6 AA alkaline batteries for the vehicle
and 2 AA alkaline batteries for the transmitter.
Batteries not included.
Vehicle
1. Remove the battery door.
2. Install 6 AA batteries (not included), with polarity
(+/-) as shown inside the battery compartment.
3. Replace the battery door.
Transmitter
1. Open the battery door as shown.
2. Install 2 AA alkaline batteries with polarity (+/-) as
shown inside the battery compartment.
3. Close the battery door.
Ä
Your transmitter is equipped with a special auto-
matic ON battery-saving feature. Just turn your
vehicle ON. Then push either transmitter control
to run and control your vehicle.
w
q
e
q
w
e

Summary

Battery Installation

Vehicle Battery Installation

Install 6 AA batteries into the vehicle's battery compartment, observing correct polarity as shown.

Transmitter Battery Installation

Install 2 AA batteries into the transmitter's battery compartment, observing correct polarity as shown.

Vehicle Operation

Basic Movement Controls

Illustrates forward, reverse, left, and right movement controls for the vehicle via the transmitter.

Battery Safety and Information

Battery Performance Note

Guidance on using alkaline batteries for optimal performance and battery life variation.

Consumer Warranty Information

Details the 90-day limited warranty covering defects in material and workmanship.

Mattel Tyco R/C Stunt Psycho Specifications