To Next PageTo Next Page
Need help?Do you have a question about the Matthews Marking Systems I-Mark SX-32e and is the answer not in the manual?
General| Brand | Matthews Marking Systems |
|---|---|
| Model | I-Mark SX-32e |
| Category | Printer |
| Language | English |
Disclaimers regarding the manufacturer's right to change specifications and liability.
Information on safety symbols and CE marking compliance for the printer.
Disclaimer regarding CE directive compliance for altered or improperly installed printers.
Details on product name, serial number, and manufacturer information on the device.
Printer is CE marked and complies with EMC Rules for industrial environments.
Manual contains installation info for SX-32e, refers to operator manual for basic procedures.
Explanation of how to interpret icons and arrow paths in the manual's instructions.
Identifies and describes the main components of the SX-32e printer system.
Lists the items included with the SX-32e printer upon purchase.
Explains the function of each component (Control Unit, Print Head, etc.) in the system.
Details the front, rear, and side views of the control unit and its keyboard.
Provides the physical size specifications and weight of the SX-32e control unit.
Instructions for mechanically setting up system components before connecting to the control unit.
Details on placing the SX-32e control unit on a surface or mounting it.
Information on connecting up to four print heads and their proper mounting orientation.
Explains the function of the printout activator and guidelines for its installation.
Describes the function of the speed encoder in adjusting print gap based on conveyor speed.
Details on connecting external devices via RS-232 serial interface and specifications.
General guidance on connecting various external components to the control unit.
Diagrams and instructions for connecting different types of print heads to the control unit.
Instructions for connecting printout activators and speed encoders to the control unit.
Guidance on connecting devices via RS-232 serial interface.
Describes the print relay function and signal output via the I/O encoder port.
Steps for configuring the control unit to match the installation environment.
Instructions for setting display language, measurement units, and zero format.
Parameters for setting up the control unit to match the mechanical aspects of the installation.
Steps to monitor and troubleshoot input signal status for printout and speed encoder.
Procedure for testing the functionality of each print head using test messages.
Information on setting user levels (Basic, Advanced, Full) and password protection.
Details on how the mounting bracket kit allows vertical or horizontal fixing of the SX-32e.
Instructions for rotating the lower section of the control unit for cable access.
Steps for attaching the wall bracket to the SX-32e and mounting it to a surface.
Procedure for initial setup, including setting display language.
Instructions on how to reset the SX-32e to its default factory configuration.
Table showing the default settings for various parameters of the SX-32e.
Advice for optimizing barcode print quality and scanner readability.
Table listing common printout problems, their possible causes, and remedies.
Details common printout faults detected after printing and their solutions.
Table listing faults detected within the SX-32e control unit and their remedies.
Provides detailed technical specifications for the SX-32e printer.
Table showing manual versions, issue dates, and software compatibility.
Pages for recording custom parameter settings for future reference or replication.
