8
MATWELD, INC. PHONE:(270) 444-0085 FAX:(270) 443-6180
Matweld reserves the right to change parts, features, or specifications without notice.
9/99
03900A REVERSING RAIL SAW
FLOW: 10 GPM (38 LPM)
PRESSURE: 2000 PSI (140 BAR)
BACK PRESSURE: MAX 250 PSI
RPM: 3200
OPERATION:
1. POSITION SAW CLAMP SQUARELY ON RAIL AND TIGHTEN.
2. ATTACH THE RAIL SAW TO THE CLAMP ASSEMBLY AND TIGHTEN.
3. WITH THE POWER SOURCE IN THE “OFF” POSITION, CONNECT THE HOSES. DO NOT
DRAG THE SERVICE HOSE BY PULLING WITH THE TOOL. LOOP THE SERVICE HOSE IN
THE WORK AREA IN SUCH A WAY TO RELIEVE STRESS ON THE HOSE AND QUICK DIS-
CONNECT FITTINGS WHILE WORKING. BE AWARE OF HOSE LOCATION AT ALL TIMES.
KEEP HOSES CLEAR OF SPARKS.
4. TURN POWER SOURCE TO THE “ON” POSITION TO SUPPLY 10 GPM TO TOOL.
5. GRASP THE SAW FIRMLY AND PULL UP ON THE TRIGGER TO START THE SAW BLADE
ROTATING. BEFORE USING, RUN SAW BLADE FOR ONE MINUTE AT FULL SPEED TO CHECK
FOR DEFECTS OR VIBRATION BEFORE TOUCHING RAIL. THE SAW IS DESIGNED TO
THROW SPARKS AWAY FROM THE OPERATOR.
6. KEEP THE SAW OSCILLATING WHILE MAKING THE CUT. THIS WILL REDUCE GLAZING
AND CUTTING TIME.
7. THE OPERATOR CAN START FROM EITHER SIDE OF THE RAIL OR ROTATE TO THE OPPO-
SITE SIDE OF THE RAIL TO COMPLETE THE CUT. TO ROTATE THE SAW, RELEASE THE
TRIGGER TO STOP THE SAW AND WITHOUT MOVING THE CLAMP SIMPLY PIVOT THE
SAW OVER AND MOVE TO THE OPPOSITE SIDE OF THE RAIL. YOUR SAWING POSITION
WILL CHANGE BUT IT IS DESIGNED SO THAT YOU WILL STILL BE PULLING UP ON THE
TRIGGER TO RESUME CUTTING. KEEP CLEAR OF THE TRIGGER AND BLADE WHILE
CHANGING POSITIONS. ENSURE HOSE IS ROUTED AWAY FROM SPARKS.
8. AFTER FINISHING THE CUT, TURN THE POWER SOURCE “OFF” AND DISCONNECT HOSES
BEFORE ATTEMPTING TO REMOVE THE SAW.
REV.8/04
To Next Page
Loading...
