14
4. NEVER USE THE MACHINE IN AN
UNSTABLE PLACE.
Never use it in a place where it could move
or fall of itself.
Be sure to install the compressor on a flat
floor, with leg rubber underneath it; the al-
lowable tilt angle of the floor is up to 10 de-
grees. If the installation floor is tilted and
slippery, ensure that the compressor does
not move during operation. Do not use it on
a shelf or a stand where it may fall or tumble.
5. USE THE MACHINE IN THE APPROPRIATE
DIRECTION.
Install it appropriately.
6. NEVER INSTALL THE MACHINE IN THE
RAIN OR IN A PLACE SPLASHED WITH
WATER OR EXPOSED TO HIGH TEMPER-
ATURE.
Using it in the wet condition could cause an
electric shock or a short-circuit, resulting in a
fire due to burnout or ignition.
7. AVOIDING A PLACE EXPOSED TO HIGH
TEMPERATURE OR THE DIRECT SUN-
SHINE, BE SURE TO USE THE MACHINE
IN THE WELL-VENTILATED SHADE.
Using it under high temperature or in the di-
rect sunshine not only deteriorates its dura-
bility, but increases the temperature of the
main body, causing danger to your safety.
Be sure to use it in the well-ventilated shade.
The adequate room temperature is +5°C to
+30°C (41°F to 86°F). Maximum is 0°C to
+40°C (32°F to 104°F).
8. NEVER BLOCK A VENTILATION OPEN-
ING OR USE THE MACHINE IN A BOX OR
A NARROW PLACE(IN A VEHICLE, ETC.)
Neglect of this may generate abnormal heat,
causing a trouble or an accident.
Install the compressor at the distance of 1 m
or more from the wall to secure sufficient
ventilation and cooling.
9. DO NOT USE THE COMPRESSOR IN ANY
PLACE WHERE THE TEMPERATURE IS
0°C (32°F) OR LESS OR THE AMBIENT
TEMPERATURE EXCEEDS +40°C (104°F).
To Next Page
Loading...
Need help?
General
