Max KB1 - Panel Control and External Ports; Top panel control; External ports on the rear panel

Loudspeaker
Power
Fingered chord
Single chord
Record
Start/Stop
Program
AUDIO INPUT
MIC
PHONES/OUTPUT
DC 9V
PHONES/
OUTPUT
AUDIO
INPUT
9V
MIC
Precautions
Read it carefully before proceeding.
Content Pages
I. Panel Control and External Ports …………………………… …… … 1
II. Performance Preparation …………………………… … ……………… 2
III. Basic Performance Method..……………………… …………….. …....2
IV. Auto Rhythm ………………………………………… ……………...… ... 3
V. Auto Bass Chord …………………………………… ……………………. . 4
VI. ……………………………………… …….......…. ...5
VII. ………… ….……. 5
VIII. …………………… .........6
…… … .
…… …… ..
…… ……
…… …… .
…… …… .
Effect Control ………… ……
Recording and Rhythm Programming ……………… ……..
Three-step Intelligent Training ……………………
Appendix I. Timbre Table ……………………...……………………………………...7
Appendix II. Rhythm Table……………………………………………..……….........9
...…
●
goes wrong.
● Neither disassemble the instrument nor make any change inside of it. In case of any anomalous
function, stop using immediately and have it repaired by the qualified maintenance personnel.
● Make sure that the both are power off when connecting the instrument with other amplifiers.
● Don’t leave the volume working in maximum or in uncomfortable stage for long time.
● Keep the instrument away from the heats, which may result in the damage of the components.
● Stop any liquid, or other particles getting into the instrument, which may corrode the body or result in
short circuit .
● Unplug the instrument before cleaning it and avoid using wet hands to plug or unplug it.
● Clean the instrument with a piece of dry and soft cloth without paint, alcohol or other chemical steep.
● Turn off and unplug the instrument after performance or for a long time of leaving it unused.
● Warning! Do not get it close to the ear! Misuse may cause damage to hearing.
● The supply terminals are not to be short-circuited.
● The packing has to be kept since it contains important information.
● To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The apparatus
shall not be exposed to dripping or splashing and that no objects fill e d w i th liquids, such as vases,
shall be placed on the apparatus.
● Maximum Operating Temperature:40°C
● Direct plug-in adaptor is used as disconnect device, the disconnect device shall remain readily operable.
● Do not install this equipment in a confined space such as a book case or similar unit, and remain a well
ventilation conditions. The ventilation should not be impeded by covering the ventilation openings with
items such as newspaper, table-cloths, curtains etc.
● Correct Disposal of this product. This marking indicates that this product should not be disposed
with other h o u s e hold wast e s throughou t throughout the EU. To p r e v e n t possib l e ha r m to
the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of m a t e rial resources. To return your used device, please u s e
the return and collection systems or cont act the retailer where the p roduct was p u r chased. They
can take t h i s produ c t for environmental safe recycling.
Warning: Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Caution: Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent
type.
Warning: Excessive sound pressure from earphones and headphones can cause hearing loss.
Only apply the designated power supply adaptor. Change it whenever it shows any wear and tear, or
Sync
Play
Fill-in
Keyboard Percussion
Sustain
Vibrato
LCD screen
One-Key
Follow
Ensemble
Timbre
Rhythm
Demo Song
Numbers
Master Volume
Accom volume
Tempo
Percussions
Chord Zone
I. Panel Control and External Ports
● Top panel control
● External ports on the rear panel