From Speakerphone
1. Press key
2. When you hear the dial tone, dial the desired number.
3. The unit will start to time the conversation after 6 seconds.
4. When finished, press key again.
Pre-dialing function
1. When the handset is on the base, dial the desired number.
2. If there are mistakes, use the DEL key to edit.
3. Press key or pick up the handset and the number will be dialed automatically.
Redial
1. Pick up the handset or press key,
2. Press REDIAL key, the last dialed number will be dialed again
Auto-redial (this function just for your selection)
1. Press key, dial a number, if you hear an engaged tone.
2. Press ARD key and the last dialed number will be redialed automatically at every 9-10
seconds until the line is through.
3. The phone will redial the same number automatically for 32 times.
When there is an incoming call while using auto-redial, pick up the handset or press key to
answer the call. The auto redial function will be terminated.
REVIEWING, CALLING BACK AND DELETING INCOMING NUMBERS
Reviewing
In on-hook state, press UP/+ or DOWN/– key to scroll and review the numbers.
Deleting
When the desired number is shown, press DEL key, the number is deleted.
Press and hold DEL key for 3 seconds; all the incoming numbers are deleted.
Calling back
1. Scroll to the desired number, press key or pick up the handset, and the number is dialed
out,
2. Or press REDIAL key, LCD displays PICK UP, press key or pick up the handset, the
number is dialed out.
3. Or press and hold REDIAL key till PICK UP flashing, press key or pick up the handset,
the number is dialed out. If the long distance code is set, the telephone will add the long
distance code ahead the number automatically and then dial back. If the PABX code is set,
the telephone will detect and add the code before the number when dialing back the
number. It will dial the PABX code first and then after a 2 second pause and then dial the
number.
To Next Page
Loading...
Need help?
General