7
Making SOS calls
Make sure that the phone has the SOS ALARM function enabled
(Settings > SOS Settings > SOS Key), then press the SOS button
on the FW735 SOS bracelet for 3 seconds, the blue LED light will
start flashing for about 15 seconds. After doing this, the MM735 will
start calling the numbers defined in the ICE contacts (if the first
emergency number does not answer, the phone will make a call to
the next one, etc.). In the absence of defined ICE contacts, the
phone will dial the 112 emergency number. Flashing red LED on
bracelet indicates that the connection has failed. Please check that
the phone has been correctly configured with the bracelet.
Attention:
The FW735 bracelet is only used to initiate an SOS call made by
phone.
You can't talk through it.
The FW735 bracelet is not factory paired with the phone.
Pairing the SOS bracelet with your phone .
1. Press the button on the bracelet once (the red LED will
flash for one minute)
2. Then, in MM735 phone , select: SETTINGS > SOS
SETTINGS > CONNECT WITH BRACELET.
Once connected, the LED on the bracelet will flash briefly three
times. At the same time, the icon will appear on the MM735 phone
display .
If the FW735 SOS bracelet does not connect to the MM735 within
one minute, it will go into sleep mode, to activate it, press the button
on the bracelet again.
• If the symbol appears on the phone, it means that the
bracelet has lost connection, e.g. due to lack of coverage or
the phone being turned off.
To Next Page
Loading...
Need help?
General
