Maxi-Cosi Pebble 360 User Manual

65
I
Pebble 360 40cm-83cm / max. 13 kg
I
Maxi-Cosi
Pebble 360 in airplanes
• Installation of the Pebble 360 on an aircraft seat
diers from the installation on a car seat.
• Installing the Pebble 360 with a 2-point safety belt is
only allowed when used in an aircraft.
• In an aircraft, the Pebble 360 may only be used on
forward-facing passenger seats.
• To install Pebble 360, place the infant carrier rearward
facing on the passenger seat.
Route the webbing of the-2point safety belt through
the belt guides. (1,2)
Lock the buckle of the 2-point safety belt. (3)
And tighten the 2-point safety belt by pulling on the
tightening strap. (4)
• The handle of the Pebble 360 must be in upright
position.
• The belt buckle must not be positioned between
the belt hooks of this car seat. Otherwise a safe
attachment does not exist.
• To uninstall Pebble 360, open the buckle of the
2-point safety belt by lifting the lever of the buckle. (5)
And remove the webbing of the 2-point safety belt
from the guides. Make sure the Pebble 360 does not fall
from passenger seat when opening the buckle.
• The Pebble 360 must remain belted on the aircraft
seat, even when unoccupied.
• The Pebble 360 is only for use on an aircraft seat
authorized by the airline.
• Do not install the Pebble 360 in the area of airbag
deployment.
• Instructions of the cabin crew must be followed.
• The safety of your child for not complying with the
installation and instruction manual is not guaranteed.
CARE
• The cover, inlay, belt pads and sun canopy of the car
seat can be removed for washing. The front baleen of
the sun canopy needs to be removed before washing.
The harness webbing can be cleaned by using a wet
cloth.
• The plastic inserts of the shoulder pads do not need
to be removed before washing.
EN

Maxi-Cosi Pebble 360 Specifications

General

Product color	Green