Ad
e
C
f
G
FIG. 9
B
44
4
TH
STEP: TURNING ON
• Connect the supply cable to a 220V plug provided with
earth. Three red lights appear on display “e”.
• For the vacuum cleaner function: press push button “B” and
ad just the power by means of keys +/-.
• For the steam function: press push button “A”, after
about 5 minutes pilot light “d” lights up and the
device reaches the optimum working temperature and
pressure. The steam must be adjusted by means of the
knob (fig.9) according to the surface to be treated.
The temperature remains displayed on the display. Once the
other functions are selected, the display shows them about
5 seconds.
NOTES: when pilot light “f” signalling that the water is finished
is on, the flashing writing “H2o” appears on the display and in
the meantime the steam delivery is stopped. In this case fill the
tank with water. (step 2).
• For the iron / carpet cleaner function: press push button
“C”, the corresponding pilot light lights up and the writing
“ACC” appears on the display.
• Power Jet: this function allows improving steam effectiveness
in removing dirt, especially for the cleaning of carpets/
mouquettes/quilts. An high pressure pump injects some
liquid together with steam. It is possible to use normal water
or, if necessary, a specific detergent diluted in water (dilution
percentage: 2-10%).
Press the steam push button (push button A). When steam
is ready (pilot light “d” on) press push button G, the
corresponding pilot light will turn on. To select the desired
programme, press push button G several times within 5
seconds:
P1 Minimum P2 Median P3 Maximum P4 Continous jet.
• Cold wash: press button “G” without starting the steam
function (button “A”). The word jEt will appear on the
display.
NOTES: once the detergent has finished in the tank, the diplay
will show the “dEt” message; at the same time, the detergent
supply will stop. In such a case, fill the rear tank.
LIST OF THE PANELS FUNCTIONS
A. Push button to turn the boiler on
B. Push button to start and adjust the
motor (+/-)
C. Push button to start the iron / carpet cleaner
d. Pilot light signalling the steam is ready
e. Display
f. Pilot light signalling the water is finished
G. Push button Power Jet
To Next Page
Loading...
