Spangenberg International B.V. – Rendementsweg 24P – 3641 SL Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
info@spangenberg.nl – www.spangenberg.nl
Cut the remaining sealing tape on the two sides enable to fold it.
Put plastic parts on the two sides of sealing bar.
Install the stailes steel base and pressing stick.
Connect the cable of complete sealing bar to the pin, then put the sealing bar back to vacuum chamber to finish the installation.
Cleaning and Maintenance
Always remove the plug from the socket before cleaning the machine.
ATTENTION! Never immerse the machine in water or any other liquid!
Clean the outside and the inside of the machine with a damp cloth (water with mild detergent).
Never use aggressive cleaning agents or abrasives. Do not use any sharp or pointed objects. Do
not use petrol or solvents! Do not use abrasive materials.
To Next Page
Loading...
