17
TM
OPERATION
NOTE: Do not exceed the operating pressure of the air tool.
The regulated pressure gauge measures the hose pressure.
1
2
1
1
4. Plug in the power cord (1) of the
compressor to the electrical outlet
(2). Turn ON the power supply to the
compressor (FIG. H).
5. Turn the AUTO/OFF switch (1) to AUTO
position. Let the motor run (FIG. I).
6. Adjust the hose pressure gradually with
respect to the operating pressure of the
air tool by turning the pressure regulator
knob (1) clockwise (FIG. J).
To Next Page
Loading...
Need help?
General