39
Troubleshooting the GV60
1. Is the room temperature and the time showing on the
remote display?
A blank display could indicate that the 9Volt battery in the
handset needs to be replaced.
2. Does the motor turn the knob when the UP & DOWN
flame buttons on the handset are pushed?
Dead receiver batteries or the handset is not synced.
(See slide 25)
3. Is the handset in the SUN TEMP, MOON TEMP, or
TIMER mode?
Unit may be OFF because the set temperature is lower than
the room temperature.
4. Has the handset been out of range for 6 hours?
No communication for 6 hours will cause the fireplace to go to
STANDBY mode.
5. Have you verified transmission of signal?
Handset – radio signal flashes when pressing UP & DOWN
flame button.
Receiver – beeps to confirm receipt of signal.
© 2013, Maxitrol Company
f i r e - p a r t s . c o m
To Next Page
Loading...
