Charging and installing the SIM card
It is recommended to use a charger of output parameters of 5V 1A. The total
charging time of the watch is approximately 2 hours. Open the plug protecting the
microUSB port, connect the included microUSB cable, and connect the device to a
power source.
Always make sure your watch is turned off before inserting or removing the
SIM card. Open the back cover of the smartwatch by gently prying it at the top and
sides until the latches are unfastened. Remove the battery taking care not to
damage the battery cables and remember its position. Open the micro SIM card
cover by sliding it slightly to the right, and then insert the SIM card into the slot in
such a way that the sim card chip is facing upwards to the watch screen. Then close
the lock by sliding to the left. Place the battery in the watch in its original position,
then close the back cover by pressing the latches.
1. The home screen shows the current date and time as well as the battery
level. On this screen, we also see the icon for connecting to the mobile
network.
2. Enables you to make a phone call by manually entering the number.
3. The phone book gives you access to 10 contacts defined using the
application.
4. Allows you to take a photo that will be saved in the album.
5. Access to the last photo taken. You can preview, send or delete it. Each
subsequent photo taken overwrites the previous one.
6. A simple math game with three levels.
7. It allows you to send voice messages and receive text and voice messages.
8. Start the flashlight built into the watch.
9. Read the registration QR code for the device and the application QR code.
To Next Page
Loading...
