Operating Instructions APS Series
MaxLite Energy Saving Power Strip (8 Receptacles/Surge Protection)
Models:
APS-8/1350J
(Advanced Power Strip with 8 receptacles and 1350 Joules of surge protection)
1 primary (master)
5 secondary (energy saver)
2 constant outlets
How to use your Energy Saving Power Strip
1. Plug your primary device (ex. television or computer into the Master
(primary) outlet.
2. Plug your peripherals (ex. game system, DVD player, printer, lamp) into the
energy saver (secondary) outlets.
3. When you turn your primary device (television) on, you will then notice everything
plugged into your energy saver (secondary) outlets turns on.
4. When you turn your primary device (television) off, you will then notice everything
plugged into your energy saver (secondary) outlets turns off.
5. Of course, there may be electronic devices that you want to keep on at all times.
If this is the case, simply plug these devices into the constant outlets and they will
not be affected and will always remain on.
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Page: 1
REV: 1/02/20
®
Installation & Operation
Picture is for illustration purposes only.
Your model may vary.
RESET
OFF
GROUNDED
PROTECTED
MASTER
ENERGY SAVER
ALWAYS ON
grounded LED
indicator light
surge LED
indicator light
5 secondary outlets (energy saver)
controlled by primary outlet
4 foot (1.2m), 14/3
SJT power cord
lighted circuit breaker
on/off switch
2 constant
outlets
primary outlet (master)
(this outlet controls
the secondary outlets)
multiple
threshold
switch
To Next Page
Need help?
General