8
D&S DISTORTION & SUSTAINER
FEATURES AND CONTROLS
●Amazingly long sustain and hot distortion without spoiling your guitarʼs original
tone.
●D&S produces a wide variety of distortion from heavy and thick distortion sugges-
tive of vacuum tube amplifier to extreme vintage fuzz.
①DISTORTION (Distortion Control)
Controls distortion and sustain level.
Rotate this volume clockwise for
more distortion and sustain.
②TONE (Tone Control)
Controls effect tone. Rotate this vol-
ume clockwise to emphasize middle
and high tone range.
③BALANCE (Balance Control)
Controls output level of effected
tone. Typically output levels of both
normal tone and effected tone
should be adjusted to equal levels.
④NORMAL / EFFECT
(Normal / Effect Switch)
Switch for effect on/off. Stepping on
this switch alternately turns effects
on (LED on) and off (LED off).
⑤INDICATOR (LED Indicator)
It lights on when effects are on and
lights off when effects are off. It also
indicates battery condition. Dark or
no LED light indicates the battery is
low or not installed. Replace the
battery.
⑥INSTRUMENT (Instrument Jack)
Input jack to connect to the output of
guitar, other effects or related equip-
ment. The product automatically
turns on when you put a plug into
this jack. Pull out the plug when not
in use.
⑦AMPLIFIER (Amplifier Jack)
Output jack to connect to the input
of amplifier or other effects.
⑧DC IN (Power Input Jack)
A jack to connect AC adaptor.
To Next Page
Loading...
