6
PROGRAMMING INSTRUCTIONS
Remove the battery compartment door.
BEFORE INSTALLING BATTERIES, locate
the channel programming dip switches at
the upper left corner. To select an operating
channel, move the switches per the chart
below (we suggest you use a pointed utensil
like a ball point pen). All radios must be on
the same frequency to communicate with
each other. NOTE: Switch 5 is not used in
programming.
Example of dip switches set for Channel 9:
Switch: 1/down 2/down 3/down 4/up
Channel 1* - Frequency 462.5625 MHz
Switch: 1/up 2/up 3/up 4/up
Channel 1* - Frequency 462.5625 MHz
Switch: 1/down 2/up 3/up 4/up
Channel 1* - Frequency 462.5625 MHz
Switch: 1/down 2/down 3/down 4/down
*NOTE: There are three combinations for Channel
1, any can be used.
1 2 3 4 5
To Next Page
Loading...