Maxon

SL25 - Status Indicators & Audible Alert Tones; Scan Modes; Normal Channel Scan; Scan Channel Delete

STATUS INDICATORS &
AUDIBLE ALERT TONES
Your SL25 Series radio has a sophisticated microprocessor
control which provides a series of audible alert tones.
Upon initial power-up, a quick melody indicates that the radio
is ready to use. Tones also sound indicating the following
conditions:
 Attempt to transmit on a channel that is already in use
 Attempt to transmit on the scan channel
 Low battery condition
SCAN MODES
Scanning is a feature available in some countries that allows
you to monitor a number of channels. Once the scan
channel is selected via the channel selector knob Á, scan is
initiated.
To check if your radio is capable of scanning, contact your
Maxon reseller.
NORMAL CHANNEL SCAN
If your radio is capable of scanning you can initiate scan.
Simply move the channel selector knob to the scan channel
position (last channel) and the radio will start to scan the
remaining channels on your radio. The top panel LED will
flash green as the radio is scanning.
If a conversation is detected on any of the other channels,
the radio will stop on that channel and you will be able to
hear the conversation. The radio will resume scanning once
you have completed your conversation. Scanning will
continue until the channel is changed.
SCAN CHANNEL DELETE
To temporarily delete a channel from the scan list, simply
press the monitor button while scanning has stopped on the
channel to be deleted. This will remove that channel from the
scan list until the channel is changed or the radios power is
reset.
When power is restored or the scan list channel position is
again selected, the original programmed scan list will be
activated.
ENGLISH
9