Model #: 40334
IMPORTANT: Read all instructions carefully before use.
ASSEMBLY AND OPERATING INSTRUCTIONS
The Perfect Solar Light for Flags or Signs
Your MAXSA Solar Flag Light converts sunlight into electricity during
the day, enabling the Super bright LED light to turn on automatically
at night to light up your flag.
ABOUT YOUR SOLAR-POWERED FLAG LIGHT
Page 1
Carefully remove and identify all the parts from their protective
packaging and lay them out in front of you.
INCLUDED PARTS
MOUNTING TO A FLAGPOLE
To mount on a flagpole, position the flagpole mounting bracket
supplied against the flagpole and run the two supplied metal bands
through the bracket as shown.
Put the bracket up to the pole and close the metal bands around the
pole, making sure the bands are pulled tight so the light is firmly
secured.
CAUTION: Tigthening the metal bands means they cannot be
reopened, the only way to remove them is to cut them. Make
sure to tighten them only after ensuring that your Solar Flag
Light is positioned exactly where you want it.*
HOW TO INSTALL YOUR SOLAR-POWERED FLAG LIGHT
OPERATING YOUR SOLAR POWERED FLAG LIGHT
BEFORE USING YOUR SOLAR-POWERED FLAG LIGHT
Leave your solar panel outside in direct sunlight for 3 full days,
keeping the power switch to OFF during that period. This will ensure
that the batteries in your Solar Flag Light have a full charge prior to
normanl operations.
After the initial 3 day charge of your Solar Flag Light, press the
switch on the main body to the ON position to make the light turn on
automatically after sundown. Your Solar Flag Light is now ready for
use.
Depending on how long you prefer the light to last, you can
double the light duration and reduce the brightness by pushing the
brightness control switch so that you get up to 6 hours of light at full
brightness or up to 12 hours at ½ brightness so you can light up
your flag all night. If the weather is not sunny for multiple
consecutive days, consider turning the switch to OFF.
NOTE: When you first turn the light ON, it should activate
immediately, regardless of lighting conditions or motion. This is a
test activation to show there is power flowing from the battery to the
light. It
should last roughly seconds. After this test activation, the
light will function normally.
Position the solar panel so that it faces the southern sky. Placing the
panel in a shaded location will not allow the batteries to charge fully,
reducing the number of hours the light will operate per evening.
The Solar Powered Flag Light is equipped with a light-sensitive
trigger to automatically turn the light on at dusk. For best
performance, ensure that the Flag Light is not placed near nighttime
light sources such as porch lighting and street lighting.
CHOOSING A SUITABLE LOCATION
Your Solar Flag Light can light for up to 6 hours at full power and
up to 12 hours at half power/brightness when the batteries are
fully charged. This light comes with 3 AA rechargeable and
removable NiMH 1200 mAh batteries. When the charging ability of
the batteries decreases, they will need to be replaced.
Flag Light Main
Body
2 Metal Mounting
Bands
To Next Page
Need help?
General