The bypassing options are as follows:
[0] Bypass Open Zones – This section will only display the zones which are currently open or bypassed. Use
the arrow (< >) keys to scroll through these zones. Zones that are open will be indicated by an exclamation
(!) mark in the lower right hand side of the keypad display.
To select a zone to be bypassed, press the [*] key. A “*” will appear next to the zone label to indicate that
the zone has been bypassed. When you are done selecting zones, press [#] to exit.
[1] Bypass Zones – This selection takes you immediately to bypassing zones. Use the arrow (< >) keys to nd
the zone to be bypassed and press the [*] key to select it. A “*” will appear next to the zone label to indicate
that the zone has been bypassed. When you are done selecting zones, press [#] to exit.
[2] Clear Bypasses – This selection will allow you to turn bypassing o for all of the zones in your partition.
[3] Recall Bypasses – This selection will automatically bypass the same group of zones which were bypassed
the last time the partition was armed.
[4] Previous Menu – This selection will return the display to “Enter Code to Arm System.” From here, you will
be able to arm the system.
To Previous Page
Loading...
