Need help?Do you have a question about the MAXTHERMO MC-2538 and is the answer not in the manual?
Details the operation flow for the user level, including parameter settings.
Details the PID control level operation flow and parameter settings.
Describes the operation flow for input level settings and configuration.
Details the operation flow for setting parameters and advanced configuration.
Configuring dual output for heating and cooling modes.
Setting up loop broken alarms for loop short or loop open.
Configuring program parameters including segments, ramp, and soak.
Enabling remote set value (SV) functionality.
Setting up master and slaver communication between units.
Configuring ramp and soak profiles for process control.
Setting up and controlling motor valves.
Configuring SCR output for resistance loads.
Setting up analogue signal outputs (e.g., 4-20mA).
Configuring analogue signal inputs (e.g., 4-20mA).
Details available input types and ranges for sensors.
Details available output types and ratings.
Lists available control modes like ON/OFF, P, I, D.
General| Input Type | Thermocouple K |
|---|---|
| Output | Relay |
| Control Mode | PID |
| Display | LED |
| Operating Temperature | 0°C to 50°C |
| Input | Thermocouple |
To Next Page
