15
max
80
km/h
STEP 5
Insert the 12 V plug into the auxiliary pocket of
the car, start up the engine and have it running
throughout the whole repairing operation
WARNING
If the engine runs in an indoor place there is a
serious risk of death.
STEP 6
Press the start button on the compressor and inflate until
you reach the desired pressure. Turn the compressor
off, unscrew the hose (warning: it’s hot), disconnect the
wire and drive not later than a minute to spread around
the sealant pumped into the Tire.
Warning: every ten minutes turn the compressor
off for at least three minutes.
STEP 7
Drive for 2 or 3 miles and then re-examine the Tire
and inflate to the pressure listed on handbook.
English
To Next Page
Loading...
