6
MACRO BUTTONS PROGRAMMING
You can use this function to edit the MACRO key to control the device that you want
to control according to the steps that you set.
An example of a Macro function:
TV turn on, automatically switches TV to AV output, turns DVD turn on, then
turns on the DVD player.
1. Press and hold the [TV] button and [POWER] button at the same time,
for about 3 seconds until the device LED indicator lights up. Then release both
buttons.
2. Enter the operation code “9960”, the TV buttons LED will blink twice then
illuminate to indicate remote has entered MARCO mode.
3. Then press the [TV] button, [POWER] button, [AV] button, [DVD] button, [POWER]
button. [PLAY] button and finally press the [OK] button to save the MACRO
programmed functions and exits.
4. Now, if you press the MACRO button, the remote control perform automatically
the functions as stated in the above example.
NOTE:
1. You can only programme a maximum of 15 buttons functions. If you go over this
limit the lights will automatically go out
2. If you require 2 MACRO setups on your remote control, please enter these two
separate codes MACRO1 is 9960 and MACRO2 is 9961.
DELETING PROGRAMMED MACRO SETTINGS
1. Press and hold the [TV] button and [POWER] button at the same time,
for about 3 seconds until the device LED indicator lights up. Then release both
buttons.
2. Enter the operation code “9960”, TV button led blink twice then light up to
indicate remote enter MARCO mode.
3. Press the OK button to clear your setting.
To Next Page
Loading...
