Maxview URC6D - Learning Commands Procedure; Clearing Learned Commands; Troubleshooting Common Issues

You can use this feature to check the four digit code every device you have
set up;. Follow these steps using the remote control keypad:
1. Press the device button that you want to check, such as [TV].
2. Press and hold the [POWER] button whilst inputting these numbers in this
sequence [1] or [2] or [3], [4]. Then release all buttons
3. On the keypad there should now be 4 lit flashing numbers which indicate the
devices code number.
NOTE:
1. If the digit code number is “0”, the device button will blink 10 times.
For example: for four-digit code is “1095”, then:
POWER+1 The led will blink 1 time
POWER+2 The led will blink 10 times
POWER+3 The led will blink 9 times,
POWER+4 The led will blink 5 times
This function allows you to increase or decrease volume without having to use
your TV. Follow the steps below to enable or disable this function:
1. Press and hold just one of the device buttons and [POWER] button at the same
time, for about 3 seconds until the device LED indicator lights up, then release
both buttons.
2. Enter the operation code “9100” to enable this function or entry “9110” to disable
this function. After completion the LED will blink twice.
3. Press the [TV] button and the LED will blink twice and exit mode.
This function allows you to control PLAY, REW, FF, REC, STOP and PAUSE functions
on all linked devices on just one remote control. Follow the steps below to enable or
disable this function:
You can follow these steps as below to enable or disable this function:
1. Press and hold just one of the device buttons and [POWER] button at the same
time, for about 3 seconds until the device LED indicator lights up, then release
both buttons.
2. Enter the operation code “9120” to enable this function or entry “9130” to disable
this function. After completion the LED will blink twice.
3. Press the [TV] button and the LED will blink twice and exit mode.
You can use this function to lock your remote to avoid children operating your
device/s. Follow the steps below to enable or disable this function:
1. Press and hold the [OK] button for about 7 seconds to enable this function, then
the LED will blink twice and go out.
2. Press and hold the [EXIT] button for about 7 second to disable this function, then
the LED will blink twice and go out.
You can use this function to reset your remote control to it’s original factory settings.
All functions will be cleared. Follow the steps below to reset your remote control
1. Press and hold just one of the device buttons and [POWER] button at the same
time, for about 3 seconds until the device LED indicator lights up, then release
both buttons.
2. Enter the operation code “9300” and the LED will blink twice and go out.
3. Your remote control has now been reset to the original factory settings.
CHILD LOCK & UNLOCK
RESET TO ORIGINAL FACTORY SETTINGS
TRANSPORT PUNCH THROUGH FUNCTION
VOLUME PUNCH THROUGH FUNCTION
7
CHECKING THE CODES