MaxxMar Cool Motion - Original Solo-A1 Motor Operation; Motor Unit Assembly and Charging; Setting Motor Limits and Rotation

Solo-A1 - Original Maxx Motor (without Bluetooth)
Rechargeable Wand Control System with Internal Battery Motor
12V DC with Battery Charger
Motor Unit Assembling
- Hang switch wand hanger with motor adapter
- Connect switch wand cable pin to the motor
Battery Charging
- Charging motor battery: use a DC5V plug charger
- Please recharge motor battery when motor alarm sounds off
(DI, DI-DI) or motor begins to falter
- Charging time: 7 hours - please take the charger away
when charging is complete
Original Solo-A1
MAXX MOTORS
Operation & Programming Instructions
Command
Item
Key Combination
Description
Illustration
Change
Motor
Rotation
Direction
Lower
Limit
Setting
1 Press UP button
If motor goes up, please do
nothing. If motor goes
down, please do next step
1
Press and hold
SETTING button
on wand
Press and hold
SETTING button
then press STOP
button
Press UP button
2
3
Release both buttons
when motor sounds DI-DI-DI
Motor goes up, the motor
rotation direction has been
revised
2
3
4
5
Press DOWN
button
Just Press
SETTING button
Press STOP button
when close to the
lower limit position
Press UP or DOWN
button to adjust the
finally position
Release buttons
when motor sounds DI-DI-DI
Motor goes down
Motor stops
Motor sounds DI-DI-DI
lower limit setting has been set
Basic Operation & Troubleshooting
MaxxMotor Original-Instructions_Layout 1 20-02-06 10:29 AM Page 1