1
CONTENTS
ASSEMBLY
SET-UP
PLAY
2 3 4
1 2
3 4
1 2
CORKSCREW
ORBEEZ PACKS (2)
MOTOR UNIT
SPA HOOD
SPA TUB
1.1
1.2
BATTERY INSTALLATION
1.1 Open the battery door on the MOTOR UNIT
using a philips screwdriver (not included).
1.2 Install 3 new “AA” (LR06) alkaline batteries
(not included) as shown.
1.3 Replace battery door and tighten screw.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard
(carbon-zinc), or rechargeable (nickel
cadmium) batteries.
•
Remove and discard exhausted
batteries properly as soon as possible.
•
Remove all batteries from compartment
if toy is not used for a long period
(several months).
•
The supply terminals are
not to be short-circuited.
CAUTION:
BATTERIES MUST BE INSTALLED BY AN ADULT.
REQUIRES 3 “AA” (LR06) BATTERIES.
NOT INCLUDED.
Insert the CORKSCREW into the CYLINDER and
attach it to the square peg in the MOTOR UNIT.
Install the assembled MOTOR UNIT into the SPA TUB.
CYLINDER rests where arrows point. CORKSCREW
rests over “GEARED” SUPPORT.
Align TABS on SPA HOOD with SLOTS in
SPA TUB and snap them together.
UP
GEARED
CORKSCREW
SUPPORT
Pour the contents of 1 Orbeez pack into the SPA TUB.
Add bottled or distilled water. To keep fresh longer, add a small pinch of salt.
DO NOT EXCEED THE FILL LINE to avoid submerging the batteries!
FILL LINE
Leave to soak for four hours, or overnight.
Once Orbeez have reached full size, drain all of the excess water out.
Do NOT pour Orbeez down the drain.
Place clean feet into the SPA TUB and relax. Remain seated.
CAUTION: SLIPPERY! Do NOT stand up in the SPA TUB.
Press BUTTON to start the waterfall action.
To Previous Page
Loading...