Do you have a question about the MAYA ORBEEZ and is the answer not in the manual?
Open the battery compartment door on the motor unit using a screwdriver.
Remove old batteries and install three new 'AA' alkaline batteries as shown.
Replace the battery compartment door and tighten the screw.
Orbeez can be stored in a sealable bag or jar to prevent them from drying out.
Replace Orbeez after a few uses and dry completely between uses. Add salt to keep fresh longer.
Install three 'AA' (LR06) alkaline batteries into the motor unit, following safety cautions.
Insert the corkscrew into the cylinder and attach it to the square peg in the motor unit.
Install the assembled motor unit into the spa tub, aligning parts correctly.
Align the tabs on the spa hood with the slots in the spa tub and snap them together.
Add bottled or distilled water up to the fill line, adding salt for freshness.
Pour the contents of one Orbeez pack into the spa tub.
Allow the Orbeez to soak for at least four hours or overnight to reach full size.
Once Orbeez are hydrated, drain all excess water from the spa tub.
Press the button to activate the waterfall and soothing spa action.
Place clean feet into the spa tub and relax. Remain seated for safety.