Spotting/Filming
NOTES:
• Liquid rinse aid is necessary for drying and to reduce spotting.
• Use the correct amount of detergent.
Confirm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes. If the cloudiness disappears, it
is due to hard water. Adjust the amount of detergent and rinse aid. (See "Dishwasher Care" section.) If it does not come
clear, it is due to etching (see below).
Be sure the incoming water temperature is set at 120°F (49°C).
Try using the Hi Temp or Steam Sanitize option.
To remove spotting, see "Dishwasher Care" section.
Dishwasher does
not drain
Be sure the cycle has been completed (the green light is on). If the cycle has not been completed, you will need to resume
the cycle by pressing START/RESUME and closing the door within 4 seconds.
If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed from the disposer inlet.
Check for kinks in the drain hose.
Check for food obstructions in the air gap, drain hose, or disposer.
Check your house fuse or circuit breaker.
@
To Next Page
Loading...
Need help?
General
