Maytag MFI2665XE User Manual

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
MFI2665XE
MFI2670XE
Electrical: A 115-volt, 60-Hz, AC-only, 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate
circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned
off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of
installation, cleaning, or removing a light
bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the
refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired
setting. See “Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207 and
827 kPa) is required to operate ice maker
and water dispenser. If you have questions
about your water pressure, call a licensed,
qualified plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis Water Supply: If a
reverse osmosis water filtration system is
connected to your cold water supply, the
water pressure to the reverse osmosis
system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10314958
1/20/11
3³⁄₄" (9.5 cm)
¹⁄₂" (1.25 cm)
To ensure proper ventilation for your refrigerator, allow for a
1
⁄2" (1.25 cm) space on
each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If
your refrigerator has an ice maker, make sure you leave some extra space at the
back for the water line connections.
If you are installing your refrigerator next to a fixed wall, leave 3
3
⁄4" (9.5 cm)
minimum on the hinge side (depending on your model) to allow for the door to
swing open.
NOTE: It is recommended that you do not install the refrigerator near an oven,
radiator, or other heat source, nor in a location where the temperature will fall below
55°F (13°C).
Model
Number
Height -
Overall
“A”
Height -
Top of
Cabinet
“B”
Depth -
Doors Open
90°
“C”
Depth -
Drawer
Open
“D”
Depth -
With
Handles
“E”
Depth -
Without
Handles
“F”
Depth -
Cabinet
Only
“G”
Width -
Cabinet
“H”
Width -
Door
Open 90°
“I”
26 cu. ft.
70
1
⁄8"
(178.1 cm)
68
5
⁄8"
(174.3 cm)
48"
(121.9 cm)
54"
(137.2 cm)
35
1
⁄4"
(89.5 cm)
32
7
⁄8"
(83.5 cm)
29"
(73.7 cm)
35
5
⁄8"
(90.5 cm)
39
3
⁄8"
(100 cm)
A
overall
B
top of
cabinet
H
not incl.
handle
F
incl.
handle
E
D
cabinet
G
90˚90˚
C
I
Bottom Mount Refrigerator

Maytag MFI2665XE Specifications

General

Brand	Maytag
Model	MFI2665XE
Category	Refrigerator
Language	English

Summary

Product Model Numbers

Product Dimensions

Electrical Requirements

Specifies a 115-volt, 60-Hz, AC-only, 15- or 20-amp fused, grounded electrical supply.

Water Supply Requirements

Requires cold water supply with pressure between 30-120 psi (207-827 kPa) for ice maker and dispenser.

Reverse Osmosis Water Pressure

Reverse osmosis systems need minimum 40-60 psi (276-414 kPa) water pressure for refrigerator connection.

Location Requirements

Ventilation Space Guidelines

Allow 1/2" (1.25 cm) space on sides/top and 1" (2.54 cm) behind refrigerator for ventilation.

Wall Clearance for Door Swing

Requires minimum 3¾" (9.5 cm) clearance on hinge side for door to swing open next to a fixed wall.

Installation Environment Recommendations

Avoid installing near heat sources like ovens or radiators; maintain temperature above 55°F (13°C).