44
FOR SERVICE TECHNICIAN’S USE ONLY
REMOVING THE DRUM LIGHT ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Open the dryer door.
4. Remove the screw from the drum light lens (see Figure A) and remove
the lens (see Figure B).
Figure A
Figure B
5. Remove the bulb from the drum light socket.
6. Remove the screw from the drum light holder and pull it forward so you can
access the wires.
7. Disconnect the wire connectors from the light socket terminals.
A. Connectors B. Light Socket
8. Squeeze the locking arms and remove the socket from the drum light holder.
A
B
A
To Next Page
