7
Tools Needed:
203 mm (8") 203 mm (8") or 254 mm (10") Flat-blade screwdriver Phillips screwdriver
or 254 mm (10") Adjustable wrench
Pipe wrench (that opens to 25 mm [1"])
TORX T20
†
Security 25 mm (1") Hex-head 8 mm (5/16") Socket wrench Pliers
screwdriver or bit socket wrench (that open to 39 mm [1
9
/
16
"])
Level Utility knife 6 mm (1/4") Nut driver Locking pliers
Caulk gun and caulk Vent clamps Pipe-joint compound 686 mm (27") Wood block
(for installing new exhaust vent) suitable for gas type
Flashlight (optional) 13 mm (1/2") and 14 mm (9/16") Ruler or measuring tape Putty knife
Open-end wrenches
TOOLS & PARTS
†TORX and T20 are trademarks of Acument Intellectual Properties, LLC.
NOTE: The circuit diagram for this dryer is located inside the lower front toe panel, within the Tech Sheets.
Parts Supplied:
SPECIFICATIONS
These units are sold in multiple regions with different
requirements for measuring capacity. Below are a few
of the valid forms of measure posted on this product:
Dry Linen Capacity: A weight measure that reects a minimum
threshold for dry volume capacity that is needed for import tariff
purposes.
IEC Capacity: The capacity measure that represents the
maximum capacity of dry linens and textiles which the
manufacturer declares can be treated in a specic cycle.
Dry Linen Capacity
10.5 Kg (23 lb)
IEC Capacity
9 Kg (20 lb)
Sound Level
Lpa: 58 dB(A) (Kpa+/-10 dB(A))
Foot Boots (4)
(Located in bag
inside the drum)
Leveling Legs (4)
(Already installed
on your dryer)
To Next Page
