11
MAINTENANCE
Handle/ Tank / Soleplate
• These areas should be wiped clean using
a soft cloth.
• Stubborn soils on the soleplate may be
wiped off using a cloth that contains a mild
detergent or water. In particular, the
soleplate can become soiled if glue or other
adhesive materials are used when pressing.
To remove this residue, heat the iron and
run the soleplate over a cotton rag.
• Do not use scrub brushes, polishing
powders, thinners, benzene, bleach or
other harsh cleaning materials.
•To avoid scratching the soleplate, never
place the iron on rough surfaces such as
zippers, metal fasteners, etc.
Be sure that the electrical plug has been removed from the electrical outlet and wait until
the iron COOLS DOWN before proceeding with maintenance tips!!
Charging Pins
• Use a dry cloth to
clean any dirt and
debris from the
pins.
To Next Page
Loading...
