Storing the Refrigerator .....................................
Vacations Moving
If you will be gone for a month or less, leave the con- When moving, follow steps a-d under Vacations. In
trois at the usual settings, addition, remove and carefully pack any items that are
During longer absences: easily removable. Ship the refrigerator in an upright
a) remove all food, position with the doors taped shut.
b) shut off the ice maker (if installed) and the valve
where you tapped into the water line to supply the
refrigerator,
c) disconnect the refrigerator from the electrical outlet,
d) clean and dry the refrigerator thoroughly,
e) leave the doors open to prevent odors.
Care and Cleaning ........................ .......................
Refer to the chart on the following page for specific No Clean TM commercial-duty
refrigerator cleaning guidelines. Condenser
Disconnect th_ A clean condenser means more efficient refrigerator
operation. Thanks to the unique design of the No
;. Clean TM condenser there's no longer a need for routine
____C-leanlnnUnder the ....._,.ReCr;nera*orcondensercleaning in normal home usage surroundings.
Some operating environments may be particularly dusty
Your refrigerator can be rolled out for cleaning the floor or greasy. In these situations, the condenser can be peri-
underneath. Raise the locking feet if engaged (see page odically cleaned to insure maximum efficiency.
3). Pull the refrigerator straight out from the wall.
Replacing a Light Bulb
ii
as
Always use a standard 40 or 60 watt appliance bulb.
Refrigerator Freezer
There are two light bulbs located under the top of the The freezeR light is located on the back wall, near the
refrigerator compartment, on either side of the Dual upper right corner.
CoolTM control housing. To remove the bulb cover:
• Carefully grasp the lightbulb by reaching behind the • Grasp the top and bottom of the bulb cover. Press in
bulb cover, the areas of the attachment tabs, applying enough
• Unscrew the light bulb and replace, pressure to unhook the tabs. At the same time, pivot
the cover down and remove.
• Unscrew the lightbulb and replace.
• Replace the bulb cover by pivoting it back into place
and snapping the tabs into the appropriate slots.
13
To Next Page
Loading...
Need help?
General
