SmarTach ACTIA L2000 Digital Tachograph
The appearance of the tachograph is shown in Figure 9.
Graphic presentation of the information on paper has the same structure as a regular diagram disc
of electronic-mechanical tachographs. At the same time in digital tachographs there is no necessity to
change diagram discs when the drivers swap and to change them daily. One paper (cash) tape is
enough for 15–20 days trip.
Figure 9 –SmarTach ACTIA L2000 Digital tachograph
Display
Display screen is divided into two zones:
– top zone, consisting of two lines, intended for the representation of the current information;
– bottom zone, consisting of one line, intended for the representation of presence or absence
of the first or second driver, as well as the kinds of the driver’s activities. Left half of this line
refers to the first driver, the right one – to the second.
Note: first driver is the driver currently driving the vehicle.
Connector for programmer
or computer
Signal indicator
Display
Printer
Buttons for
shifting along
the menu
The buttons of the activity choice,
start/finishing of the trip,
inset/retrieval of the card
Slot for the card
of driver 1
Slot for the card
of driver 2
To Next Page
Loading...