- Rotating the holder 4 anticlockwise with the help of lengthener 3 shaft of hoist 5, to lower
spare wheel
- To set free holder from wheel disk
- lifting of spare wheel is made in graduality reverse to descent
Before wheel lifting it is necessary to direct the rope to locate a hook on the middle of link rail
To the Driver’s attention!
During the lifting of spare wheel it is necessary to pay attention to the correctness of rope
reeling on the drum, especially first coils. Rope must be reeled on regular without embedding.
It is not allowed during maintenance to set tyres of different sizes, constructions, models with
different types of projector drawings and also tyres and wheels of different manufacturers.
It is forbidden to operate a vehicle, with tyres of different types of projector Figureset on the
rear axle, except temporary setting for driving to the nearest parking or repair station with
necessary compliance of security measurements.
1 – bracket; 2 – nut; 3 – lengthener; 4 – handle;
5 – lifter; 6 – holder
Figure 30 –fastening of spare wheel (MAZ-555035)
To Next Page
Loading...