Amount of
lubricant
Renewal (adding)
interval
Lubrication (filling) point
Number
of
lubricati
on
(filling)
points
Main makes,
Application season
Foreign analogues (brand,
specification, company)
filling
rating
total for a
truck
Main make
Lubrication (oil filling,
change) instructions
Rate of drain
(accumulation) of used
oil
5 ZF 6S850** for
automobiles with Deutz с
engines
1
7,5* l 7,5* l For oil change
recommendations see
operation manual of ZF
gearbox (attached to the
automobile)
EO
Check up the level of oil
and, if necessary, fill it up
to the check hole level.
–ZF 9S1310, 9S1315TO for
automobiles with Deutz
engines
Transmission oils according to the
specification ZF TE-ML 02 dated 12.2001:
Class 02А, degree of quality under API GL-4, –
mineral base ( viscosity class SAE 80W / 80W-85 / 80W-
90)
From specification
ZF TE-ML 02 А:
CEPSA Transmisiones EP Multigrado
80W-90
INA Transmol 80W-90
Transmission oils
Viscosity class SAE:
In summer:
90 (from minus 12°С to
plus 38°С)
In winter:
80W (from minus 26°С to
plus 21°С)
All-season:
75W-80 (from minus 40°С
to plus 30°С )
75W-90 (from minus 40°С
to plus 38°С )
80W-90 (from minus 26°С
to plus 38°С )
85W-90 (from minus 12°С
to plus 38°С )
85W-140 for tropics
For ZF:
Under American
classification a degree of
quality API: GL-4, НАТО:
MIL-L-2105
Under ZF classification
TE-ML 02
Under МАN regulations
M3343 (API GL-4+5)
М341 (API GL-4)
8,8* l 8,8* l
Under specification
TE-ML 02
for oil classes:
02А - 90 thous. km of
run, but not rarer than
1 time a year
02В/С/Н - 160
thous. km of run, but
not rarer than 1 time a
year
02D/L - 300 thous.
km of run, but not rarer
than 1 time in 2 years
When changing oil, clean
the magnetic drain plug,
change the seal ring, tighten
the plug with 120 Nm
moment.
* – amount of oil at primary filling, when oil changed the necessary amount thereof can decrease by 2–3 liters, when PTO installed the amount of oil increases by 0,7–1 l.
** – for the running-in period of 2000 km it is obligatory to make filling with Class 02D
To Next Page
Loading...