Amount of
lubricant
Renewal (adding)
interval
Lubrication (filling) point
Number
of
lubricati
on
(filling)
points
Main makes,
Application season
Foreign analogues (brand,
specification, company)
filling
rating
total for a
truck
Main make
Lubrication (oil filling,
change) instructions
Rate of drain
(accumulation) of used
oil
6 Final drive housing 1 ТО-2000
− rear axle
15 l 15 l А
15,2 l 15,2 l
− intermediate axle
2С
*С
for
mixture
Change oil after running-in
Check up the level of oil
and, if necessary, fill it up
to the check filling hole
level.
Drain used oil, fill fresh oil
up to the check filling hole
level.
Drain rate – 12 l
7 Wheel gear housing 2 2,0 l 4,0 l ТО-2000
− rear axle
А
− intermediate axle
2С
*С
for
mixture
Change oil after running-in
Check up the level of oil
and, if necessary, fill it up
to the check filling hole
level.
At that the hole shall be
located in the extreme lower
position.
Drain used oil, fill fresh oil
up to the check filling hole
level.
Drain rate – 3,6 l
8 Rear axle equalizer
bar housing of 3-axle
automobiles
2
All-season:
Transmission oil ТАД17И (TAD17I)
(up to minus 30
0
С)
ТМ-5-18, API GL-5
*Mixture:
85% ТАД17И (TAD17I) +15% diesel fue
«А», «З»
(below minus 30
0
С)
Transmission oils
Viscosity class SAE:
In summer:
SAE 90 (from minus 12°С
up to plus 38°С)
In winter:
SAE80W (from minus
26°С up to plus 21°С)
All-season:
75W-80 (from minus 40°С
up to plus 30°С )
75W-90 (from minus 40°С
up to plus 38°С )
80W-90 (from minus 26°С
up to plus 38°С )
85W-90 (from minus 12°С
up to plus 38°С )
Under American
classification API GL-
3/4/5 MIL-L-2105
Under classification ZF
TE-ML 02/05/07/12
Under МАN regulations
M3343 (API GL-4+5)
М341 (API GL-4),
М342 (API GL-5)
0,4 l 0,8 2С Change oil, for doing this:
remove the cover and wash
it, drain oil, install the cover,
fill fresh oil up to the lower
edge of the filler hole.
At running-in and handing-
over of the automobile for
sale check up the level of oil
and, if necessary, carry out
refilling.
Drain rate – 0,7 l
To Next Page
Loading...