Amount of
lubricant
Renewal (adding)
interval
Lubrication (filling) point
Number
of
lubricati
on
(filling)
points
Main makes,
Application season
Foreign analogues (brand,
specification, company)
filling
rating
total for a
truck
Main make
Lubrication (oil filling,
change) instructions
Rate of drain
(accumulation) of used
oil
9 Final drive housing
(hypoid type)
1 17,0 l 17,0 l ТО-2000 Change oil after running-in
− rear axle
А
Check up the level of oil
and, if necessary, fill it up
to the check filling hole
level.
2С
− intermediate axle
Drain used oil, fill fresh oil
up to the lower level of the
filler hole.
Drain rate – 16 l
10 Driving axles hubs 2 2,0 l 4,0 l ТО-2000 Change oil after running-in
− rear axle
А Check up the level of oil
and, if necessary, fill it up
to the check filling hole
level.
At that the hole shall be
located in the extreme lower
position.
− intermediate axle
All-season:
Hypoid transmission oil
ТМ-4-18 API GL-4
ТСп-14гип
(up to minus 30
0
С)
Hypoid transmission oils
Viscosity class SAE:
In summer:
SAE 90 (from minus 12°С
up to plus 38°С)
In winter:
SAE80W (from minus
26°С up to plus 21°С)
All-season:
75W-80 (from minus 40°С
up to plus 30°С )
75W-90 (from minus 40°С
up to plus 38°С )
80W-90 (from minus 26°С
up to plus 38°С )
85W-90 (from minus 12°С
up to plus 38°С )
Under American
classification API GL-4/5
MIL-L-2105
Under classification ZF TE-
ML 01/05/07/
Under МАN regulations
M3343 (API GL-4+5) М341
(API GL-4),
М342 (API GL-5)
2С Drain used oil, fill fresh oil
up to the lower level of the
filler hole.
Drain rate – 2,5 l
To Next Page
Loading...