6. Fluid level should be at the
bottom of the opening.
7. Add enough fluid through the
filler opening so that the fluid
level is at the bottom of the
opening.
8. Install and tighten the fill plug
securely.
Use only fluid that meets Mazda specifications. Refer to Lubricant
Specifications in this chapter.
Checking and adding transfer case fluid (if equipped)
Vehicle must be on level surface.
1. Clean the filler plug.
2. Remove the filler plug and
inspect the fluid level.
3. Assure the vehicle cannot move.
4. Add only enough fluid through
the filler opening so that the
fluid level is at the bottom of
the opening.
Maintenance and Specifications
226
To Next Page
Loading...
