Black plate (143,1)
qABS Warning Light
í
The warning light stays on for a few
seconds when the ignition switch is turned
to the ON posit ion.
If the ABS war ning light stays on while
you're driving, the ABS contr ol unit has
detected a system malfunction. If this
occurs, your brakes will function normally
as if the vehicle had no ABS.
Should this happen, consult an Authorized
Mazda Dealer as soon as possible.
WARNING
ABS Warning Light and Brake
Warning Light on at the Same Time:
Driving when the brake system
warning light and ABS warning light
are on at the same time is d angerous.
When both lights are on, the rear
wheels could lock more quickl y in an
emergency stop than under normal
circumstances.
Don't drive with both light s on, and
contact an Authorized Mazda Dealer
to have the brakes inspected as soon
as possible.
NOTE
l
When the engine is jump-started to
charge the battery, uneven rpm
occurs and the ABS warning light
comes on. This is due to a weak
battery, not a malfunct ion.
Recharge the battery.
l
When the ABS warning ligh t
remains illuminated, the power
sliding doors cannot be opened
electrically. Refer to “Power Sliding
Doors” (page 3-12).
qBrake Pad Wear Indicator
When the disc brake pads become worn,
the built-in wear indicators contact the
disc plates. This causes a screeching noise
to warn that the pads should be replaced.
When you hear this noise, consult an
Authorized Mazda Dealer as soon as
possible.
Driving Your Mazda
Starting and Driving
5-7
í
Some models.
Mazda MPV_8T51-EC-04G_Edition3 Page143
Friday, December 17 2004 11:11 AM
Form No.8T51-EC-04G
To Next Page
Loading...
Need help?
General
