Black plate (271,1)
qChanging Coolant (Without Rear
Heater)
Change coolant according to Scheduled
Maintenance (page 8-3).
CAUTION
l
Use only soft (demineralized) water
in the coolant mixture. Water that
contains minerals will cut down on
the coolant's effectiveness.
l
Don't add only water. Always add a
proper coolant mixture.
l
The engine has aluminum parts and
must be protected by an ethylene-
glycol-based coolant to prevent
corrosion and freezing.
l
DO NOT USE coolants Containing
Alcohol, methanol, Borate or
Silicate.
These coolants could damage the
cooling system.
l
DO NOT MIX alcohol or methanol
with the coolant. This cou ld damage
the cooling system.
l
Don't use a solution that contains
more than 60% antifreeze.
This would reduce effectiveness.
NOTE
If the “FL22” mark is shown on or near
the cooling system cap, use FL22 type
engine coolant. If engine coolant other
than FL22 type is used, the engine
coolant must be replaced earlier than
the specified replacement interval
indicated in the scheduled maintenance
(page 8-3).
For mixture percentage:
Protection
Volume
Antifreeze
solution
Demineralized
water
Above
_
16°C (3°F) 35% 65%
Above
_
26°C (
_
15°F) 45% 55%
Above
_
40°C (
_
40°F) 55% 45%
Maintenance and Care
Owner Maintenance
8-15
Mazda MPV_8T51-EC-04G_Edition3 Page271
Friday, December 17 2004 11:13 AM
Form No.8T51-EC-04G
To Next Page
Loading...
Need help?
General
