Black plate (292,1)
2. Push the tab as shown in the figure,
and then remove the high-mount brake
light unit.
3. Turn the socket and bulb assembly
counterclockwise and remove it.
4. Disconnect the bulb from the socket.
5. Install the new bulb in the reverse order
of removal.
NOTE
An unsecured high-mount brake light
will allow water to leak into the vehicle.
Make sure the high-mount brake light is
tightly fastened to the vehicle and if
water still leaks, consult an Authorized
Mazda Dealer.
License plate lights
1. Slide the unit as shown in the figure to
remove it.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order
of removal.
qReplacing Interior Light Bulbs
Overhead light/Map lights
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens and remove the lens by careful ly
prying on the edge of the lens with the
screwdriver.
2. Disconnect the bulb by pull ing it out.
8-36
Maintenance and Care
Owner Maintenance
Mazda MPV_8T51-EC-04G_Edition3 Page292
Friday, December 17 2004 11:13 AM
Form No.8T51-EC-04G
To Next Page
Loading...
Need help?
General
