SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Child-safety
Seats
Child-safety seat
To install in 2nd row outboard
seats: Use dual locking mode
retractor seat belts; see Owner’s
Manual for proper installation
and child seat tether and LATCH
system instructions
WARNING: Read all
information and warnings
in Owner’s Manual and
attached to seat before
using child-safety seat
Safety belt emergency
locking mode
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more
Automatic locking mode
(front passenger and all
rear safety belts only)
Must be used when installing
child-safety seat
To activate: Pull belt fully out of
retractor, allow belt to retract until
click is heard; belt will only tighten
To disengage: Unbuckle belt and
allow belt to retract fully
WARNING: Make sure all seats
are properly latched, because
during a sudden stop or
collision the seat or seatback
could move, causing injury
Third-row seat
Insert seat belts in retainers;
remove head restraints; pull strap
(1), push seatback toward front of
vehicle until it locks with a click
Pull strap (2); release the lock of
front seat legs
Pull strap (3); lift seatback and
seat bottom up to vertical; gently
lower the seat into seat well
To Next Page
Loading...
